Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1244

AUX – Sensor Controller Registers
Table 17-43. VECCFG1 Register Field Descriptions (continued)
Bit Field
12-8 VEC3_EV
7 RESERVED
6 VEC2_POL
5 VEC2_EN
1244
AUX – Sensor Controller with Digital and Analog Peripherals
Type Reset Description
R/W 0h
Selects vector 3 trigger source event.
0h = AON_RTC_CH2 event
1h = AUX_COMPA event
2h = AUX_COMPB event
3h = TDC_DONE event
4h = TIMER0_EV event
5h = TIMER1_EV event
6h = SMPH_AUTOTAKE_DONE event
7h = ADC_DONE event
8h = ADC_FIFO_ALMOST_FULL event
9h = OBSMUX0 event
Ah = OBSMUX1 event
Bh = AON_SW event
Ch = AON_PROG_WU event
Dh = AUXIO0 input data
Eh = AUXIO1 input data
Fh = AUXIO2 input data
10h = AUXIO3 input data
11h = AUXIO4 input data
12h = AUXIO5 input data
13h = AUXIO6 input data
14h = AUXIO7 input data
15h = AUXIO8 input data
16h = AUXIO9 input data
17h = AUXIO10 input data
18h = AUXIO11 input data
19h = AUXIO12 input data
1Ah = AUXIO13 input data
1Bh = AUXIO14 input data
1Ch = AUXIO15 input data
1Dh = ACLK_REF event
1Eh = MCU_EV event
1Fh = ADC_IRQ event
R 0h
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
R/W 0h Selects vector 2 trigger event polarity.
To manually trigger vector 2 execution, set VEC2_EV to a known
static value, and toggle VEC2_POL twice.
0h = Rising edge triggers execution.
1h = Falling edge triggers execution.
R/W 0h Enables (1) or disables (0) triggering of vector 2 execution.
When enabled, the edge selected by VEC2_POL on the event
selected by VEC2_EV will set VECFLAGS.VEC2, which in turn
triggers vector 2 execution.
Note: Lower vectors (0 and 1) have priority.
0h = Event detection is disabled
1h = An event selected by VEC2_EV with polarity from VEC2_POL
triggers a jump to vector 2 when AUX_SCE is in sleep
Copyright © 2015, Texas Instruments Incorporated
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
www.ti.com