Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1453

www.ti.com
22.10.1.13 STMPCTL Register (Offset = 34h) [reset = 0h]
STMPCTL is shown in
SampleStaMP Generator Control Register
31 30
23 22
15 14
7 6
Bit Field
31-3 RESERVED
2 OUT_RDY
1 IN_RDY
0 STMP_EN
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 22-21 and described in
Figure 22-21. STMPCTL Register
29 28
RESERVED
R-0h
21 20
RESERVED
R-0h
13 12
RESERVED
R-0h
5 4
RESERVED
R-0h
Table 22-14. STMPCTL Register Field Descriptions
Type Reset
R 0h
R 0h
R 0h
R/W 0h
Copyright © 2015, Texas Instruments Incorporated
Table 22-14.
27 26
19 18
11 10
3 2
OUT_RDY
R-0h
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Low until the output pins are ready to be started by the samplestamp
generator. When started (that is STMPOUTTRIG equals the WCLK
counter) the bit goes back low.
Low until the input pins are ready to be started by the samplestamp
generator. When started (that is STMPINTRIG equals the WCLK
counter) the bit goes back low.
Enables the samplestamp generator. The samplestamp generator
must only be enabled after it has been properly configured.
When cleared, all samplestamp generator counters and capture
values are cleared.
Integrated Interchip Sound (I2S) Module
I2S Registers
25 24
17 16
9 8
1 0
IN_RDY STMP_EN
R-0h R/W-0h
1453