Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1494

RF Core HAL
Bit Index Bit Field Name
0–1 entryType
2–3 entrySubType
4–7
8 bMceUseRam
9–11 mceRomBank
12 bRfeUseRam
13–15 rfeRomBank
16–23 mceMode
24–31 rfeMode
Bit Index Bit Field Name
0–1 entryType
2–3 entrySubType
4–7 specialType
8
9 bAutoTxIf
10 bApplyRx
11 bApplyTx
12–31 invRfFreq
Bit Index Bit Field Name
0–1 entryType
2–3 entrySubType
4–7 nextEntryRegion
8–31 addrOffset
(1)
Not recommended. Included for completeness; only works if pointer range checks have been disabled.
1494
Radio
Table 23-20. Format of an MCE/RFE Override Mode Entry
Description
11: Firmware-defined parameter
01: MCE/RFE override mode
Reserved
0: Run MCE from ROM
1: Run MCE from RAM
MCE ROM bank to run from
0: Run RFE from ROM
1: Run RFE from RAM
RFE ROM bank to run from
Mode to send to MCE
Mode to send to RFE
Table 23-21. Format of a Center Frequency Entry
Table 23-22. Format of an End of List Entry
Copyright © 2015, Texas Instruments Incorporated
Description
11: Firmware-defined parameter
10: Special configuration
0001: Center frequency entry
Reserved
If 1, set TX IF to RX IF.
If 1, use invRfFreq to recalculate RX IF.
If 1, use invRfFreq to recalculate TX shape.
Value where fRFMHz is center frequency in MHz:
(12 × 24 × 220) / (fRFMHz × loDivider)
Description
11: Firmware-defined parameter
11: End of list segment
0x0: End of list
0x1: SRAM. Base = 0x2000 0000
0x2: RF core RAM. Base = 0x2100 0000
0x3: Flash. Base = 0xA000 0000
0x4: RF core ROM. Base = 0x0000 0000
0x5: BROM. Base = 0x10000 0002
0x6. GPRAM. Base = 0x11000 0002
0x7: Registers. Base = 0x40000 0002
0x8: FCFG. Base = 0x50000 0002
0xF: End of list
Others: Reserved
Address offset for next list part. Next address is:
Base + (addrOffset × 4)
SWCU117C – February 2015 – Revised September 2015
www.ti.com
(1)
Submit Documentation Feedback