Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1491

www.ti.com
23.3.3.1.2 CMD_RADIO_SETUP: Set Up Radio Settings Command
Command ID number: 0x0802
CMD_RADIO_SETUP is a radio operation command. In addition to the parameters listed in
the command structure contains the fields listed in .
Byte Index Field
14 mode
15 loDivider
16–17 config
18–19 txPower
20–23 pRegOverride
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Table 23-15. CMD_RADIO_SETUP Command Format
Bit Index Bit Field name
0–2 frontEndMode
3 biasMode
4 bNoAdi0Setup
5 bNoAdi0Trim
6 bNoAdi0Ovr
7 bNoAdi1Setup
8 bNoAdi1Trim
9 bNoAdi1Ovr
10 bNoFsPowerup
11 lnaIbBoostg
12–15
0–5 IB
6–7 GC
8–15 tempCoeff
Copyright © 2015, Texas Instruments Incorporated
Type Description
This is the main mode to use.
0x00: BLE
0x01: IEEE 802.15.4
W 0x02: 2-Mbps GFSK
0x05: 5-Mbps coded 8-FSK
0xFF: Keep existing mode; update overrides
only.
CC13xx:
LO divider setting to use. Supported values: 0
W (equivalent to 2), 2, 5, 6, 10, 12, 15, and 30.
Value of 0 or 2 only supported for devices that
support 2.4-GHz operation.
0x00: Differential mode
0x01: Single-ended mode RFP
0x02: Single-ended mode RFN
0x03: Antenna diversity (start RFP)
0x04: Antenna diversity (start RFN)
0x05: Single-ended mode RFP with external front
end control on RF pins
0x06: Single-ended mode RFN with external
front end control on RF pins
0: Internal bias
W
1: External bias
0: Program ADI 0 with default values.
W
1: Do not program ADI 0.
0: Apply trim values to ADI 0.
W
1: Use default values for ADI 0.
0: Apply ADI 0 overrides.
W
1: Ignore ADI 0 overrides.
0: Program ADI 1 with default values.
W
1: Do not program ADI 1.
0: Apply trim values to ADI 1.
W
1: Use default values for ADI 1.
0: Apply ADI 1 overrides.
W
1: Ignore ADI 1 overrides.
0: Power up frequency synthesizer.
W
1: Do not power up frequency synthesizer.
CC13xx:
0: Set ADI_0_RF:LNACTL2.IB to 0.
W
1: Set ADI_0_RF:LNACTL2.IB to 1 and adjust
RSSI offset by 4 dB to compensate.
W Reserved
Value to write to the IB field of the CTL_PA1 ADI
W
register at 25°C
Value to write to the GC field of the CTL_PA1
W
register
Temperature coefficient for IB.
W
0: No temperature compensation
Pointer to a list of hardware and configuration
W registers to override. If NULL, no override is
used.
RF Core HAL
Table 23-8,
1491
Radio