Honda ACCORD HYBRID 2005 Service Manual page 146

Cylinder Head
R o c k e r A r m a n d S h a f t D i s a s s e m b l y / R e a s s e m b l y ( c o n t ' d )
REAR
NOTE:
• Identify parts as they are r e m o v e d so they can be reinstalled in their original locations.
• Inspect the rocker shafts and rocker arms (see page 6-45).
• Rocker arms must be installed in the same positions if reused.
• W h e n removing or installing the rocker arm assembly, do not remove the m o u n t i n g bolts. The bolts w i l l keep the
rocker arms, rocker shaft bridge, and rocker shaft on the shaft.
• If the rocker shaft does not remove or does not install by hand, remove or install the rocker shaft by heating the
rocker shaft bridge.
• Bundle the rocker arms w i t h rubber bands to keep t h e m together as a set, and remove the bands after the rocker
arms have been installed.
• Prior to reassembling, clean all the parts in solvent, dry t h e m , and apply new engine oil to any contact points.
• W h e n replacing the rocker a r m assembly, remove the fastening hardware f r o m the new rocker a r m assembly.
I N T A K E R O C K E R S H A F T R O C K E R S H A F T H O L D E R
6-44