Honda ACCORD HYBRID 2005 Service Manual page 114

Cylinder Head
V a l v e C l e a r a n c e A d j u s t m e n t ( c o n t ' d )
5. If y o u feel too much or t o o little drag, loosen the
locknut, and turn the adjusting screw until the drag
on the feeler gauge is correct.
FRONT:
6. W h i l e holding the adjusting screw w i t h the screw
driver, tighten the iocknut and recheck the
clearance. Repeat the adjustment, if necessary.
Specified Torque
Front: 14 N-m (1.4 kgf m, 10 Ibfft)
Apply new engine oil to the nut threads.
Rear: 20 N m (2.0 kgf m, 14 Ibfft)
7. Rotate the crankshaft clockwise. Align the pointer
(A) on the front upper cover w i t h the No. 4 piston
TDC mark (B) on the f r o n t camshaft pulley.
8. Check and, if necessary, adjust the valve clearance
on the No. 4 cylinder.
9. Rotate the crankshaft clockwise. A l i g n the pointer
(A) on the front upper cover w i t h the No. 2 piston
TDC mark (B) on the f r o n t camshaft pulley.
10. Check and, if necessary, adjust the valve clearance
on the No. 2 cylinder.
6-12