Cylinder Head Cover Installation - Honda ACCORD HYBRID 2005 Service Manual

Cylinder Head Cover Installation
7. Remove the three bolts (A) securing the harness
holder.
8. Remove the breather hose (B) and g r o u n d cable (C).
9. Remove the rear cylinder head cover.
FRONT
1. Check the spark plug seals for damage. If any seal
is d a m a g e d , replace it.
2. T h o r o u g h l y clean the head cover gasket and the
groove.
3. Install the head cover gasket (A) in the groove of
the cylinder head cover (B). Make sure the head
cover gasket is seated securely.
4. Clean the head cover contacting surfaces with a
shop t o w e l .
5. Set the spark plug seals (A) on the spark plug tubes,
and install the cylinder head cover (B).
6. Visually check the spark plug seals for damage.
7. Inspect the cover washers (C). Replace any washer
that is damaged or deteriorated.
(cont'd)
6-33