Knuckle Replacement - Acura 2002 RSX Service Manual

Rear Suspension
Hub Bearing Unit Replacement
(cont'dl
9. Remove the hub bearing unit (A) from the spindle.
Install the hub bearing unit in the reverse order of
removal, and note these items;
. Tighten all mounting hardware to the specified
torque values.
. Before installing the brake disc, clean the mating
surface of the hub and the inside of the brake
d r s c ,
. Use a new spindle nut on reassembly.
. After tightening, use a drift to stake the spindle
nut shoulder against the spindle.
. Use a new hub cap on reassembly.
. Before installing the wheel, clean the mating
surface ofthe brake disc and the inside ofthe
wheel.
1 0 .
18-26
\*
1 .
Knuckle Replacement
l2,2kgl,m,
i
16 tbf.ftl
,,:-_
2 .
Raise the rear of the vehicle, and support it with
safety stands in the proper location (see page 1-8).
Remove the rear wheels.
Remove the brake disc and hub bearing unit (see
step
'l
on page 18-25).
3. Remove the flange bolts {A) and splash guard (B)
from the knuckle.
A
9.8 N.m
11.0 kgf.m,
7 .2 tbl.itl
4. Remove the wheel sensor(A), braxe nose
mounting bracket (B), and parking cable mounting
bracket (c)from the knuckle. Do not disconnect the
wheel sensor connector.
8 x 1.25 mm
22 N.m
12.2
.m, 16lbf.ftl
6 x 1 . 0 m m
9.8 N.m
(1.0 kgf.m,
7.2 tbt.ft)
8 x 1.25 mm
22 N.m