Xconnect Vfi - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
eth1/0/7-VLAN102
Total Entries: 1
Switch#
111-10 vpn id
This command is used to configure the VPN ID of a VPLS.
vpn id VPN-ID
Parameters
VPN-ID
Default
None.
Command Mode
VFI Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the VPN ID of a VPLS. Each VPLS in a device should have a local
unique VPN ID.
Example
This example shows how to configure the VPN ID of a VPLS to 100.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)# vpn id 100
Switch(config-vfi)#
111-11

xconnect vfi

This command is used to create a local AC in a VPLS. Use the no command delete a local AC from a
VPLS.
xconnect vfi VPLS-NAME
no xconnect vfi VPLS-NAME
Parameters
VPLS-NAME
Up
Specifies the VPN ID of a VPLS. The value range is from 1 to
4294967295.
(Optional) Specifies the VPLS name. This name can be up to 32
1244