D-Link DXS-3600 Series Reference Manual page 1252

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
112-6 xconnect
This command is used to create the VPWS service on the interface. Use the no form of this command to
remove the VPWS service.
xconnect IP-ADDRESS VC-ID encapsulation mpls [manual] [raw | tagged] [mtu 0-65535]
no xconnect
Parameters
IP-ADDRESS
VC-ID
raw
tagged
mtu
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to create a VPWS service and enter the Xconnect configuration mode. When creating
the VPWS on a physical port or link aggregation group, the service is Ethernet-based and this Ethernet
port or link aggregation group is the AC. When creating the VPWS on a VLAN sub-interface of a switch
port interface, the service is Ethernet VLAN-based and this VLAN sub-interface of the switch port is the
AC.
Use the no xconnect command to remove a VPWS service. The settings related to the service are also
removed.
Example
This example shows how to configure the AC from the Customer Edge Bridge (CE) to the PE as the
VLAN 10 of port 1. Assume the VC's ID is 2. For making the VLAN 10 packets from CE one can be
transmitted to the other end through the MPLS network. Configure PE1 and PE2 as follows.
Configuring PE 1:
Switch# configure terminal
Switch(config)# interface ethernet1/0/1
Switch(config-if)# service encapsulation svid 10
Specifies the peer LSR ID that is used to identify the other end PE.
Specifies the PW service instance ID. The range is from 1 to
4294967295.
(Optional) Specifies that the PW type is in the Ethernet-raw mode. For
this type, S-tags will not be sent over the PW.
(Optional) Specifies that the PW type is in the Ethernet-tag mode. For
this type, S-tags will be sent over the PW. By default, the PW type is in
the Ethernet-tag mode.
(Optional) Specifies the local CE-PE link MTU that will be advertised to
remote peer. If specifies the MTU to 0, the LDP will not advertise the
local MTU. The MTU must be same at both local and remote.
Otherwise, the PW will not be setup. The valid range of this value is
from 0 to 65535. If not specified, the default MTU value is 1500.
1252