ip dos trap
ip dos trap
Sets whether the switch generates SNMP DoS traps when an attack is detected.
ip dos trap {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
This command controls whether the switch generates an SNMP trap when a DoS attack is detected. It is
assumed a DoS attack has occurred when the port scan penalty threshold is exceeded. This value is set
using the
ip dos scan threshold
Examples
-> ip dos trap enable
-> ip dos trap disable
Release History
Release 7.1.1; command introduced
Related Commands
ip dos scan threshold
show ip dos config
MIB Objects
alaDoSConfig
alaDoSTrapCnt1
page 10-92
Enables the generation of DoS traps.
Disables the generation of DoS traps.
default
enable
command.
Sets the threshold for the port scan value, at which a DoS attack is
recorded.
Displays the configuration parameters of the DoS scan for the
switch.
OmniSwitch CLI Reference Guide
IP Commands
March 2011