Configure Ospfv3 Interface Cost - Extreme Networks ExtremeWare XOS Command Reference Manual

OSPFv3 Commands

configure ospfv3 interface cost

configure ospfv3 {domain <domainName>} [vlan <vlan-name> | tunnel <tunnel-
name> | [vlan | tunnel] all]] cost [automatic | <cost>]
Description
Configures the cost of one or all interface(s).
Syntax Description
domainName
vlan-name
tunnel-name
all
automatic
cost
Default
The default cost is automatic.
Usage Guidelines
Use this command to set the cost of an interface (a VLAN or tunnel) manually, if the default cost needs
to be overwritten. The interface cost is advertised as the link cost in router-LSA.
Example
The following command configures the cost metric of the VLAN accounting:
configure ospfv3 vlan accounting cost 10
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
1376
Specifies an OSPFv3 domain. OSPF-Default is the only one currently
supported.
Specifies an IPv6 configured VLAN.
Specifies an IPv6 tunnel.
Specifies all IPv6 configured VLANs or all IPv6 tunnels.
Determine the advertised cost from the OSPFv3 metric table.
Specifies the cost metric. Range is 1 to 65535.
ExtremeWare XOS 11.3 Command Reference