Connecting To A Modem; Connecting A Vt Series Terminal - Enterasys Matrix 7G4270-12 Hardware Installation Manual

When these parameters are set, the Local Management password screen will display. Refer to the
Enterasys Matrix DFE-Platinum Series Configuration Guide for further information.
Figure 3-18 Connecting a VT Series Terminal
1 UTP cable with RJ45 connectors
2 RJ45 COM port
3.8.4

Connecting to a Modem

To connect a modem to an Enterasys Networks DFE module COM port
cable with RJ45 connectors and an optional RJ45-to-DB25 male adapter, and proceed as follows:
1. Connect the RJ45 connector at one end of the cable to the COM port of the module.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 modem adapter .
Parameter
Mode
Transmit
Bits Parity
Stop Bit
à Â
Connecting to COM Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
À
3 RJ45-to-DB25 VT adapter
4 VT series terminal
Á
(Figure 3-19), use a UTP
Installation 3-31