Example 1: Configuring Interfaces In Sonet Mode; Figure 11: Configuring Fractional T1 In Sonet Mode - Juniper JUNOSE 11.2.X PHYSICAL LAYER Configuration Manual

Example 1: Configuring Interfaces in SONET Mode

Copyright © 2010, Juniper Networks, Inc.
The following example illustrates how to configure T1 lines on channelized SONET
interfaces, as shown in Figure 11 on page 137.

Figure 11: Configuring Fractional T1 in SONET Mode

Select an OC-12 SONET controller.
1.
host1(config)#controller sonet 4/0
Configure two STS-1 paths.
2.
host1(config-controller)#path 2 oc1 1/2
host1(config-controller)#path 10 oc1 4/1
Configure two VT1.5 tributaries on SONET path channel 2.
3.
host1(config-controller)#path 2 ds1 1/2/2 vt15
host1(config-controller)#path 2 ds1 1/7/4 vt15
Configure two fractional T1 lines on VT 1/2/2 in path 2.
4.
host1(config-controller)#path 2 ds1 1/2/2 channel-group 1 timeslots 1-10
host1(config-controller)#path 2 ds1 1/2/2 channel-group 2 timeslots 11, 21-26
Configure a fractional T1 line on VT 1/7/4 in path 2.
5.
host1(config-controller)#path 2 ds1 1/7/4 channel-group 1 timeslots 2-7
Configure an unchannelized T3 on SONET path channel 10.
6.
host1(config-controller)#path 10 ds3 1 unchannelized
Configure a channelized T3 on SONET path channel 12.
7.
host1(config-controller)#path 12 ds3 1 channelized
Configure a T1 channel on the channelized T3 on SONET path channel 12.
8.
host1(config-controller)#path 12 ds3 1 t1 4
Chapter 4: Configuring Channelized OCx/STMx Interfaces
137