Example 2: Configuring Interfaces In Sdh Mode; Figure 12: Configuring Fractional E1 And Unframed E1 In Sdh Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - PHYSICAL LAYER CONFIGURATION GUIDE 2010-09-24 Configuration Manual

JunosE 11.3.x Physical Layer Configuration Guide

Example 2: Configuring Interfaces in SDH Mode

138
Configure two fractional T1 lines on the T3 in path channel 12.
9.
host1(config-controller)#path 12 ds3 1 t1 4/1 timeslots 3-8
host1(config-controller)#path 12 ds3 1 t1 4/2 timeslots 20
The following example illustrates how to configure fractional E1 and unframed E1 lines
in SDH mode, as shown in Figure 12 on page 138.

Figure 12: Configuring Fractional E1 and Unframed E1 in SDH Mode

Select an OC-12 SONET controller.
1.
host1(config)#controller sonet 4/0
Switch to SDH mode.
2.
host1(config-controller)#sdh
Configure four STM-1 paths. An OC-12 interface has four STM-1 paths.
3.
host1(config-controller)#path 10 stm1 1
host1(config-controller)#path 20 stm1 2
host1(config-controller)#path 30 stm1 3
host1(config-controller)#path 40 stm1 4
Configure a TU-12 on TUG-2 #7 on TUG-3 #2 of path 10.
4.
host1(config-controller)#path 10 e1 2/7/1 tu12
Configure a TU-12 on TUG-2 #5 on TUG-3 #2 of path 10.
5.
host1(config-controller)#path 10 e1 2/5/2 tu12
Configure a fractional E1 line on tributary 2/7/1 of path 10.
6.
host1(config-controller)#path 10 e1 2/7/1 channel-group 1 timeslots 2-5
Configure an unframed E1 line on tributary 2/5/2 of path 10.
7.
host1(config-controller)#path 10 e1 2/5/2 unframed
Copyright © 2010, Juniper Networks, Inc.