Policy Condition Destination Mac Group - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

QoS Policy Commands

policy condition destination mac group

Associates a destination MAC group with a policy condition.
policy condition condition_name destination mac group mac_group
policy condition condition_name no destination
Syntax Definitions
condition_name
mac_group
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of the command to remove a destination MAC group from a policy condition;
however, at least one classification parameter must be associated with a condition.
•
A destination MAC address and a destination MAC group cannot be specified in the same condition.
Examples
-> policy condition cond5 destination mac group mac_group1
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply
policy mac group
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition. May be an existing condition name or a new
condition.
The name of the destination MAC group, configured through the
mac group command.
Applies configured QoS and policy settings to the current configuration.
Configures a MAC group and its associated MAC addresses.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
November 2009
policy
page 39-93