Policy Condition Service Group - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

QoS Policy Commands

policy condition service group

Associates a policy service group with a policy condition.
policy condition condition_name service group service_group
policy condition condition_name no service group
Syntax Definitions
condition_name
service_group
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of the command to remove a service group from a condition; however, at least one
classification parameter must be associated with a condition.
•
A policy condition that specifies a service group cannot also specify a service, IP protocol, source IP
port, or destination IP port.
Examples
-> policy condition cond12 service group servgroup2
Release History
Release 6.6.1; command was introduced.
Related Commands
policy service group
policy condition
qos apply
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The service group name. Service groups are configured through the
policy service group
Configures a service group and its associated services.
Creates a policy condition.
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
November 2009
command.
page 39-73