Policy Condition Service - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

policy condition service

Configures a service for a policy condition.
policy condition condition_name service service_name
policy condition condition_name no service
Syntax Definitions
condition_name
service_name
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of the command to remove a service group from a condition; however, at least one
classification parameter must be associated with a condition.
•
A policy condition that specifies a service cannot also specify a service group, IP protocol, source IP
port, or destination IP port.
Examples
-> policy condition cond12 service serv2
Release History
Release 6.6.1; command was introduced.
Related Commands
policy service
qos apply
show policy service
MIB Objects
alaQoSConditionTable
alaQoSConditionService
alaQoSAppliedConditionTable
alaQoSAppliedConditionService
page 39-72
The name of the condition.
The service name, configured through the policy service command.
Configures a service that may be used as part of a policy service group.
Applies configured global QoS and policy settings to the current config-
uration (changes will be active and stored in flash).
Displays information about all particular policy services or a particular
policy service configured on the switch.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009