Table of Contents
Advertisement
Wi-Fi
b. Set the frequency band for the appropriate radio:
(config)> network wifi radio wifi1 band value
(config)>
where value is either 2400mhz or 5000mhz.
c. Set the mode for the Wi-Fi radio. For example:
n
n
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a Wi-Fi access point with no security
This procedure configures a Wi-Fi access point that does not require a password for client
connections, and uses no security or encryption.
By default, the TX54 device comes with either one or two preconfigured access points:
Single-Wi-Fi models: Digi AP (Wi-Fi).
n
Dual-Wi-Fi models: Digi AP (Wi-Fi) and Digi AP (Wi-Fi2).
n
You cannot delete default access points, but you can modify them or you can create your own access
points.
Required configuration items
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point.
n
The Service Set Identifier (SSID) for the access point.
n
Configure security for the access point to unencrypted.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
n
access point to a LAN interface or to a bridge. See
more information.
TX54 User Guide
If the Wi-Fi radio has a band of 2400mhz:
(config)> network wifi radio wifi1 2400mhz mode value
(config)>
where value is one of b, bg, bgn, g, gn, or n.
If the Wi-Fi radio has a band of 5000mhz:
(config)> network wifi radio wifi1 5000mhz mode value
(config)>
where value is one of ac, acn, or n.
Configure a Wi-Fi access point with no security
Configure a LAN
and
Configure a bridge
for
164
Advertisement
Table of Contents
