Isolate Wi-Fi Clients; Isolate Clients Connected To The Same Access Point - Digi Connect EZ 4 User Manual

Wi-Fi

Isolate Wi-Fi clients

Client isolation prevents wireless clients connected to the Connect EZ device from communicating
with other clients. There are two mechanisms for client isolation configuration:

Isolate clients connected to the same access point

n
Isolate clients connected to different access points
n
This section provides instructions for both mechanisms.
Isolate clients connected to the same access point

WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > WiFi > Access points.
4. Create a new access point or modify an existing access point. See
access point,
point with enterprise
5. Enable Isolate clients.
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
Digi Connect EZ 4/4i User Guide
Configure a Wi-Fi access point with personal
security.
Isolate Wi-Fi clients
Configure an open Wi-Fi
security, or Configure a Wi-Fi access
243