Table of Contents
Advertisement
Wi-Fi
changed.
(config)> network wifi ap digi_ap encryption group_rekey value
(config)>
where value is any number of days, hours, minutes, or seconds, and takes the format number
{d|h|m|s}.
For example, to set group rekey interval to ten minutes, enter either 10m or 600s:
(config)> network wireless ap digi_ap encryption group_rekey 600s
(config)>
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Network (LAN)
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Isolate Wi-Fi clients
Client isolation prevents wireless clients connected to the IX20Wdevice from communicating with
other clients. There are two mechanisms for client isolation configuration:
n
Isolate clients connected to the same access point
n
Isolate clients connected to different access points
This section provides instructions for both mechanisms.
Isolate clients connected to the same access point
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
IX20 User Guide
and
Configure a bridge
for more information.
Isolate Wi-Fi clients
Configure a Local Area
341
Advertisement
Table of Contents
