Show Lan Status And Statistics - Digi IX20W-PR User Manual

Interfaces
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show LAN status and statistics


Web
Log into the IX20 WebUI as a user with full Admin access rights.
1. From the menu, click Status.
2. Under Networking, click Interfaces.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
eth2
eth2
loopback
modem
modem
>
3. Additional information can be displayed by using the
> show network verbose
Interface
Weight
----------------
----
defaultip
defaultlinklocal
eth1
eth1
eth2
IX20 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.200.1.101/30
IPv6 down
Proto Status Type
----- ------- ------
IPv4 up static
IPv4 up static
IPv4 up dhcp
IPv6 up dhcp
IPv4 up static
Local Area Networks (LANs)
show network verbose command:
Zone Device
-------- --------
setup eth2
setup eth2
external eth1
external eth1
internal eth2
Metric
------ --
10 10
0 10
1 10
1 10
5 10
199