Show Lan Status And Statistics - Digi IX10 User Manual

Interfaces
3. At the config prompt, set the LAN to use a DHCP address:
(config)> network interface lan ipv4 type dhcp
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show LAN status and statistics


Web
1. Log into the IX10 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth
eth
loopback
modem
modem
>
3. Additional information can be displayed by using the
> show network verbose
Interface
IX10 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.200.1.101/30
IPv6 down
Proto Status Type
Local Area Networks (LANs)
show network verbose command:
Zone Device Metric
154