APPENDIX
b. Using the supplied cable ties, secure the coax cable from the option card to
5.2.2.12
[9]: Alarm Relay Card, Cable Installation
Additional steps for the installation of the Alarm Relay Output card (PN 1204-
0F).
a. Connect the supplied cable, part number 8195-0000-5000, to the main-
382
Figure 5-10:
J Connectors
Note:
For 10 MHz option cards with 3 coax cables: From the
rear of the option card, outputs are labeled J1, J2, J3. Start by
connecting the cable attached to J1 on the card to the first avail-
able open connector on the SecureSync mainboard, then con-
nect the cable attached to J2, then J3, etc.
the white nylon cable tie holders fastened to the mainboard.
board connector J19, pins 3 - 8.
Note: Pins 1 and 2 of connector J19 are not used:
SecureSync 2400 User Manual