Safran SecureSync 2400 User Manual page 415

Hide thumbs Also See for SecureSync 2400:

Table of Contents

The Web UI list entries for these cards are: 1PPS/Frequency BNC and 1PPS/Fre-

quency RS-485. The connector number is: J2 (Model 1204-03: RS-485 connector:

Pins 5 and 6)

The Status window displays the following settings:

Reference Priority table; see

Validity: Indicates "OK" (green) if the 1PPS input signal is present and

valid. Indicates "Not Valid" (orange) if the 1PPS input signal is either not

present or is not considered valid.

Edge: Displays the selected Edge (rising of falling) of the 1PPS input that

defines the on-time point.

Offset: Displays the configured 1PPS offset values.

The 1PPS Input signal is analyzed and an absence of the signal triggers a "Not

Valid" indication.

Frequency Input: Edit Window

To configure the settings for the Frequency Input (also referred to as 'Refer-

ence'), go to its Edit window. For instructions, see:

Inputs/Outputs" on

The Web UI list entries for these cards are: 1PPS/Frequency BNC and 1PPS/Fre-

quency RS-485. The connector number is: J1 (BNC card); J1 (RS-485 card).

SecureSync 2400 User Manual

ID: Name used to represent this 1PPS input reference in the

"Configuring Input Reference Priorities" on

for more information on reference priority configuration.

"Configuring Option Card

Troubleshooting