Connecting The Gnss Input - Safran SecureSync 2400 User Manual

2.6 Connecting the GNSS Input
2. Secure the rack mount brackets to the rack using the #10-32 rack mount
3.
2.6

Connecting the GNSS Input

Typical installations include GNSS as an external reference input. If the GNSS
receiver is not installed or if the GNSS will not be used as a SecureSync reference,
disregard the steps to install the GNSS antenna and associated cabling.
1.
50
screws and #2 Phillips head screwdriver, 2 each per side of the rack.
If you purchased additional rear rack mounts, you will align the holes with
the available pegs near the rear of the unit and slide the rail forward into
place.
Secure the mount with the screw hole closest to the front of the chassis
using 1 each of the supplied HM20R-04R7-0010 screws per side.
Figure 2-2: Rear rack mount installation
Install a GNSS antenna, surge suppressor, antenna cabling, and GNSS
preamplifier (if required). Refer to the documentation included with your
GNSS antenna for information regarding GNSS antenna installation.
Note: The SMA-to-N-type conversion cable included in the
ancillary kit is approved for pull weight of up to 60 lbs. If you
are using a heavier cable, you will need to apply appropriate
strain relief.
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2