Safran SecureSync 2400 User Manual page 538

APPENDIX
3. Assign the
4. In the Configure Reference Priorities panel, click the
5. Select a
6. Verify your settings in the
Reviewing the STL Status
Validity Status
To check or monitor the validity of the STL reference:
1. Navigate to
2. In the
522
STL receiver handles position estimation. The default setting is recom-
mended for most applications.
Sensitivity Level:
of the STL receiver towards the STL signal bursts transmitted by the
satellites. The lower the number, the more responsive the receiver will
be to acknowledge the bursts. The default value is optimized for an
indoor antenna. A higher value can be used for outdoor antenna
installations (not typical). A value lower than (40) is not recom-
mended.
STL 0 reference a reference priority by navigating to
MANAGEMENT > OTHER: Reference
right corner. The Add Reference
Priority Level:
a. If STL is to be used as a backup to GPS: Select a
b. If STL is the only reference: Select a
For Time and PPS, select STL 0. Click Submit.
new reference is Enabled.
INTERFACES >
References status panel, under
[default = 40] This value determines the sensitivity
Priority.
window will open.
Priority Level
Reference Priority
REFERENCES.
STL 0, check the status indicator
+ icon in the upper
Priority Level
of 1.
table, and ensure that the
SecureSync 2400 User Manual
of 2.