Configuring Ntp Over Anycast (Bgp) - Safran SecureSync 2400 User Manual

2.15 Configure NTP
14. Set the value
15. Set the value for
16. Leave the

2.15.12.4 Configuring NTP over Anycast (BGP)

To configure NTP over Anycast, using BGP (Border Gateway Protocol):
1. Confirm that your existing network infrastructure is Anycast capable, and
2. In the SecureSync Web UI, navigate to
3. In the
4. In the
5. On the
6. Select the port to associate the Anycast service with (depending on the
7. In the
8. On the
9. Input your
10. Input the neighbor's address.
11. Input the neighbor's AS number.
12. Click Submit.
13. Select the port address to associate the Anycast service with (because
140
(For more information about TFOM, see
page 252.)
Navigate to Management
top-right corner of the
Maximum TFOM for Sync
go out of sync if the phase error is greater than 1μs).
Holdover Timeout
holdover quickly.
Phase Error Limit
(or, for more information, see
uses BGP. Determine the network specifics, such as your Autonomous Sys-
tem (AS) number, Neighbor's address and Neighbor's AS number.
Setup.
Actions Panel, click
NTP Anycast window, select the
General tab, select your desired IP Version. This selection auto-
matically communicates with the
address field based on your needs.
option card configuration of your unit, there may be only ETH0 available). If
you desire IPv6 functionality, you must also select the IPv6 port address
since there may be multiple IPv6 addresses on a single port.
NTP Anycast window, navigate to the
BGP tab, check Enable.
AS number.
there may be multiple addresses on a single port), and click Submit. If no
addresses appear, an IP address must be added to the port.
"Configuring the Oscillator" on
> Disciplining, and click the GEAR icon in the
Status panel.
to 4 (this will make SecureSync to
to 10 s, to allow SecureSync to exit
at 0, and do not check any of the checkboxes
"Configuring the Oscillator" on
MANAGEMENT > Network > NTP
NTP over Anycast.
General
BGP tab and displays the neighbor
CHAPTER
2
page 252).
tab.
BGP tab.
•
SecureSync 2400 User Manual Rev. 5.2