Assigning Signals - Safran SecureSync 2400 User Manual

2.18 Configurable Connectors
2.18.3

Assigning Signals

Changing the signals on either the rear panel BNC DCLS connector, or on the
Multi I/O 15-pin connector requires access to the Web UI.
Configuring a new Input or Output
1. In the SecureSync Web UI, navigate to
2. View your current pin layout settings in the Layout panel. The pins are
3. To change a signal, you can
4. Add a pin configuration by clicking the PLUS icon in the top-right corner.
5. Start with the
6. From the
7. From the
8. Click Submit.
9.
Restoring the Default I/O Configuration
SecureSync is shipped with a default I/O configuration that you can be cus-
tomized. However, if required you can restore the default configuration at any
time after applying changes.
To restore the default I/O pin configuration:
A. Navigate to the
B. In the
Reloading the Current I/O Configuration
To reload the currently used I/O configuration after adding pin layout changes,
but before clicking Apply Changes:
160
Layout. The Pin Layout
grouped together by their channels (see the
mating direction from front" on the previous
will update the settings for the entire channel.
new signal as described below, thus overwriting the existing Input or Out-
put.
The Add Pin popup window will display.
Type Filter
and select a signal type.
Signal drop-down menu, select a signal.
Pins drop-down menu in line 3, select the pin set you wish to con-
figure.
In the Actions panel, click Apply Changes after all your configuration is
done. This button will finalize your changes and force a server reboot
(some timing sources may be affected by this change).
MANAGEMENT: NETWORK > Pin Layout
Actions panel on the left, click
MANAGEMENT > NETWORK: Pin
screen will be displayed.
Delete it, but you may also simply assign the
drop-down menu (second line in the window)
Restore Default
CHAPTER
2
"Multi I/O 15-pin connector, in
page). One pin in each channel
screen.
Layout.
•
SecureSync 2400 User Manual Rev. 5.2