Resetting The Gnss Receiver; Deleting The Gnss Receiver Position - Safran SecureSync 2400 User Manual

3.3.3.7

Resetting the GNSS Receiver

The Reset Receiver command causes the GNSS receiver to execute a cold start:
All data will be erased from the volatile receiver memory. Only non- volatile
memory is preserved.
Note that resetting the GNSS receiver is not the same as
Receiver Position"
To reset the GNSS Receiver:
3.3.3.8

Deleting the GNSS Receiver Position

The SecureSync timing system requires the exact geographic position in order to
calculate the exact system time from the GNSS signal.
The Delete Position command deletes the GNSS antenna position data that is
stored in the non-volatile memory of the GNSS receiver.
The deletion of the position data will automatically initiate a new GNSS self sur-
vey, provided:
CHAPTER •
3 SecureSync 2400 User Manual Rev. 5.2
Caution: Resetting the GNSS receiver may become necessary in the
rare event of internal communication issues, and is typically ONLY
required if Safran Technical Support
mand.
below.
1. Navigate to Interfaces > References: GNSS Reference
2. Click on the GEAR button next to the GNSS Reference. The
dow opens:
3. Locate the Reset Receiver
advises you to execute this com-
box, check it, and click Submit.
3.3 Managing References
"Deleting the GNSS
GNSS 0 win-
239