Notifications - Safran SecureSync 2400 User Manual

Rebooting via LCD/Keypad, Serial Port, Telnet, SSH, SNMP
With a serial connection to the front panel serial port, telnet connection or SSH
connection, type reboot <Enter> to reboot SecureSync.
Reboot is also is available to be performed through an snmpset operation. For
more information on SecureSync commands, see
Once the Reboot process has been initiated, the front panel LCD will display a
Power off message, and the front panel LED time display will stop incrementing
until SecureSync has started booting back up again.
Rebooting via the front panel
During reboot, the front panel display will read Rebooting and the time display
will stop incrementing.
4.2

Notifications

If an event occurs e.g., SecureSync transitions into Holdover, or a short is detec-
ted in the GNSS antenna, SecureSync can automatically notify users that a spe-
cific event has occurred.
In some situations, two events are generated. One event occurs in the transition
to a specified state and then another event occurs when transitioning back to the
original state. Examples of these are losing sync and then regaining sync, or
going into Holdover mode and then going out of Holdover mode. Other situ-
ations may only consist of one event. An example of this situation is switching
from one input reference to another.
Notifications of each event that may occur can be via alarms, via SNMP Traps
being sent to one or more SNMP Managers, via an email being sent to a specified
email recipient, or a combination of the three. The Notifications page allows a
user to configure whether the occurrence of each event automatically triggers an
alarm to be generated, an SNMP trap to be sent out, an email to be sent out, or a
combination of the three.
CHAPTER •
4 SecureSync 2400 User Manual Rev. 5.2
1. Press the POWER
Power Menu. Verify that you are under the Management sub menu (use the
left and right arrow keys if necessary).
2. Press DOWN until
center of the keypad once to activate the halt, and then press it again to
confirm your choice in the confirmation menu to the right.
menu button to switch the front panel display to the
Reboot is highlighted. Press the ENTER button in the
4.2 Notifications
"CLI Commands" on page 555.
263