Safran SecureSync 2400 User Manual page 535

5. Connect the antenna cable to the SecureSync unit via the SMA connector
on the option card -3E rear plate. The SecureSync can be in a powered off
or a powered on state during antenna installation.
Figure 5-57:
If the unit is ON, verify that the BURST lamp is blinking.
If the unit is OFF, turn it on, and wait until the BURST lamp is blinking.
If the BURST lamp is not blinking after the subscription has been activ-
ated, the STL receiver is not receiving an STL signal. Check the antenna
cable and its connections, and the antenna location. Move the antenna to
another location (higher or closer to an outside wall).
R e a r
BURST
indicated by the LED flashing quickly.
PPS
One (1) pulse per second means that the receiver is locked. NOTE: It can take
approximately 10 minutes or longer until the receiver is locked. This depends on
the burst rate (see
Both LEDs have equivalent indicators in the Web UI STL 0 status window:
SecureSync 2400 User Manual
Note: The supplied antenna cable is 2.4 m (96") long. Longer
cables are available upon request. The antenna does not
require a separate power supply.
Model 1204-3E option card rear plate
P l a t e L E D s :
: Indicates the incoming STL burst rate. A high burst rate (desired) is
: Indicates that the STL receiver is sending out a PPS signal to SecureSync.
"Burst Rate" on page 525
.)
APPENDIX
519