Safran SecureSync 2400 User Manual page 394

APPENDIX
b. Remove blank option card plate, or existing option card. Save the screws.
c. Place one of the supplied washers over each of the two chassis screw holes
d. Insert option card into the slot, lining up the screw holes on the card with
e. Using the supplied M3 screws, screw the board into the standoffs, and the
f. Take the supplied 50-pin ribbon cable and carefully press it into the con-
378
(see Figure below), then screw the 18 mm standoffs (the longer standoffs)
into the chassis (see Figure below), applying a torque of 0.9 Nm/8 in-lbs.
Figure 5-6: Washers & standoffs secured to chassis screw holes
the standoffs.
option card plate into the chassis, applying a torque of 0.9 Nm/8 in-lbs.
nector on the mainboard (lining up the indicated end of the cable with PIN 1
on the mainboard), then into the connector on the option card (see
Figure below).
SecureSync 2400 User Manual