Table of Contents
Advertisement
2.15 Configure NTP
1. Navigate to
2. In the
3. In the
2.15.7
NTP Reference Configuration
SecureSync's NTP Service needs to be setup such that it utilizes the time source
("input reference") you want it to use. There are two options for an NTP Server to
derive its time from:
a. The NTP Service uses SecureSync's System Time, i.e. typically the GNSS ref-
120
MANAGEMENT > OTHER: Time
System Time
panel, click the GEAR icon.
Edit System Time
will be in:
UTC: The network PCs will receive UTC time via NTP.
TAI: The network PCs will receive TAI time via NTP.
GPS: The network PCs will receive GPS time via NTP.
Note:
UTC Offset
the offset between UTC and GPS is 18 seconds.
erence (or IRIG, ASCII data input, etc.), and distributes that time over the
NTP network. This is called
be the Stratum 1 (or primary) server. This is the most common con-
figuration.
window, select the System Timescale SecureSync
When the Timescale is set to "GPS", the
must be set correctly. As of 22-August-2023,
Stratum 1
Operation, because SecureSync will
CHAPTER
Management:
GPS to
•
2
SecureSync 2400 User Manual Rev. 5.2
Advertisement
Table of Contents
Troubleshooting
