Safran SecureSync 2400 User Manual page 159

!
interface eth0
ip address 10.2.100.157/16
interface eth1
ipv6 address 2000:10:2::157/64
!
interface lo
ip address 10.10.14.1/32
ipv6 address 2000:10:10::1/64
*****************************************************
Example
configured:
(Interface eth0 line, with no lines following it because no addresses are con-
figured on the port)
*****************************************************
!
interface eth0
!
interface lo
*****************************************************
Example
*****************************************************!
router ospf
ospf router-id 10.2.100.157
network 10.2.0.0/16 area 0.0.0.0
redistribute connected
distribute-list default out connected
!
access-list default permit 10.10.14.1/32
access-list default deny any
*****************************************************
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
file showing the default file with no addresses
zebra.conf
file:
ospfd.conf
2.15 Configure NTP
143