Option Cards - Safran SecureSync 2400 User Manual

1.5

Option Cards

Option Cards are circuit boards that can be installed into a SecureSync unit in
order to add input and output functionality. Installation is normally done in the
factory when the unit is built. Many cards, however, can be retrofitted in the field
by qualified customer personnel (see
on
SecureSync has the capacity to hold either two or six option cards, depending on
whether or not an extension board is installed in your unit. If you are not sure
whether or not you have an extension board, identify the part number of your
unit:
If your product number begins with the numbers 2402, then your unit does not
contain an extension board and has a two-option card capacity. If your product
number begins with the numbers 2406, then your unit contains an extension
board, and can house up to six option cards. For more information, contact your
Safran sales personnel.
Input and outputs can be categorized by:
CHAPTER •
1 SecureSync 2400 User Manual Rev. 5.2
page 368).
In the Web UI, navigate to
figuration panel, your product number is listed under Model. OR;
On the front panel display, press the POWER
to the System submenu. Your part number is listed under Model Number.
Caution: NEVER install an option card from the back of the unit,
ALWAYS from the top. It is therefore necessary to remove the top
cover of the main chassis (housing).
Communication direction:
Input
Output
Signal type:
Frequency: 1/5/10/[programmable] MHz
Wave form (square, sinus)
"Option Card Field Installation Instructions"
TOOLS > Upgrade/Backup. In the System Con-
1.5 Option Cards
button, and navigate over
15