Rack Installation - Safran WR-Z16 User Manual

2.6

Rack Installation

The device has been designed to be mounted in a standard 19-inch (48.3 cm)
equipment rack and thus respect the following physical dimensions:
To properly mount the device to a rack cabinet:
CHAPTER •
2 WR-Z16 User Manual Rev. v5.0
Width: 431 mm
Height: 44mm (1x Rack Unit)
Depth: 300 mm
Caution:
The following guidelines are provided to prevent bodily-injury when
mounting or servicing this unit in a rack:
-This unit should be mounted at the bottom of the rack if it is the only
unit in the rack.
-When mounting this unit in a partially filled rack, load the rack from
the bottom to the top with the heaviest component at the bottom of
the rack.
-If the equipment rack is on wheels, ensure that the brakes are
engaged and that the rack is stabilized.
Note:
Accessories: The screws needed to properly mount the device to the
rack are not shipped with the equipment, nor the system ground kit.
The device already mounts the L- brackets and is provided with a
power cord C13 (European).
Note:
Airflow consideration: There are no standards for airflow in rack sys-
tem but the device should be configured accordingly to the emplace-
ment of hot and cold aisles. The default airflow of the device is from
front-panel (cold) to back-panel (hot).
1. Place the device on the floor or on a sturdy table near the rack.
2. Use a tape measure to verify the interior dimensions of the rack.
2.6 Rack Installation
17