Access Rules - Safran SecureSync 2400 User Manual

2.14 Configure Network Settings
2.14.5

Access Rules

Network access rules restrict access to only those assigned networks or nodes
defined. If no access rules are defined, access will be granted to all networks and
nodes.
To configure
1. Navigate to the
2. In the
3. The
4. In the
80
Note:
If a port is not given its own static route, all packets from
that port will be sent through the default.
Note: In order to configure Access Rules, you need
ADMINISTRATOR rights.
a new, or delete
MANAGEMENT > Network Setup
Actions panel on the left, click on
Network Access Rules
Allow From field, enter a valid IP address. It is not possible, however,
to add direct IP addresses, but instead they must be input as blocks, i.e. you
need to add /32 at the end of an IP address to ensure that only that
address is allowed.
Example: 10.2.100.29/32 will allow only 10.2.100.29 access.
I P a d d r e s s
IPv4— 10.10.0.0/16
net mask in prefix form. See the table
list of subnet mask values.
The eth0 port is the default port for static routing.
an existing access rule:
Access Control.
window displays:
n o m e n c l a t u r e :
, where 10.10.0.0 is the IP address and
"Subnet Mask Values" on page 71
CHAPTER
screen.
16
•
2 SecureSync 2400 User Manual Rev. 5.2
is the sub-
for a