Configuring Ntp Over Anycast (General Settings) - Safran SecureSync 2400 User Manual

Figure 2-10:
Figure 2-11:

2.15.12.1 Configuring NTP over Anycast (General Settings)

To setup the NTP over Anycast functionality:
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
All NTP Servers are synchronized
NTP Server 1 is out of sync
1. Confirm that your existing network infrastructure is Anycast capable.
Determine network specifics, such as the Anycast address and port.
2. In the SecureSync Web UI, navigate to
Setup.
3. In the Actions Panel, click
4. In the NTP Anycast
5. On the General tab, select the
vice for. The options are IPv4, IPv6, or both.
6. Configure the Anycast Address
7. Select the port to associate the Anycast service with (depending on the
option card configuration of your unit, there may be only ETH0 available). If
you desire IPv6 functionality, you must also select the IPv6 port address
since there may be multiple IPv6 addresses on a single port.
8. Click Submit.
MANAGEMENT
NTP over Anycast.
window, select the General
IP Version
to be used.
2.15 Configure NTP
> Network
tab.
you will be running Anycast ser-
> NTP
137