Configuring A 1Pps Output - Safran SecureSync 2400 User Manual

2.20 Configuring Outputs
1. Under
2. The Status window for the specific reference you selected will be displayed.
3. The settings window for the chosen output will be displayed. Edit the field
Configuring the settings of an output, method 2:
1. In the
2. In the Status window, click the GEAR button next to the desired output.
3.
The following configuration instructions apply to optional outputs on the basic
unit model. For specifics on outputs made available through option cards, see the
section
Note: Offset values for outputs are set in 20 ns increments and will round to the
nearest multiple of 20 if not set to one exactly.
2.20.2

Configuring a 1PPS Output

A 1PPS Output is available by default configuration through the BNC connector,
and can also be output through the Multi-I/O connector (see
nectors" on
To configure a 1PPS output:
1. Navigate to
(white on orange).
2. In the panel on the right, click the GEAR button next to the
want to edit.
170
INTERFACES >
Click the Edit button in the bottom-left corner.
(s) as desired.
INTERFACES > OUTPUTS
of the output categories
The settings window for the chosen output will be displayed. Edit the field
(s) as desired.
"Option Cards" on
page 157).
INTERFACES:
OUTPUTS, click the desired output.
drop-down menu, click OUTPUTS, or one
(not indented to the right)
page 361.
OUTPUTS, or to
CHAPTER
"Configurable Con-
INTERFACES: OPTION CARDS
1PPS Output
•
2 SecureSync 2400 User Manual Rev. 5.2
you