Table of Contents
Advertisement
PPS Pulse
Width is entered and displayed in nanoseconds (the default Pulse Width is
200 ms).
PPS Electrical
porting up to 10 V levels) signal lines.
STANAG Output: Status Window
To view the current settings of a STANAG Output, go to its Status window. For
instructions, see:
The Web UI list entries for these cards are: STANAG Out and STANAG Out, Isol-
ated.
The outputs are named: Stanag HQ Output [number].
The Status window displays the following settings:
Under General Status:
Level of Single-ended
and 1PPS Output.
Generate Time Fault Discrete
Enabled: The TFD signal uses the "Threshold to activate" value to
provide the level of TFD.
Disabled: The TFD signal is always valid.
SecureSync 2400 User Manual
Width: Configures the Pulse Width of the 1PPS output. The Pulse
Format: Selects signaling on either RS-485 or TTL (sup-
"Viewing Input/Output Configuration Settings" on
Signals: 10 V or 5V will be indicated for the TOD 1
(TFD):
APPENDIX
page 363.
459
Advertisement
Table of Contents
Troubleshooting
