Setting Up Snmp Notifications; Setting Up Email Notifications - Safran SecureSync 2400 User Manual

You can configure this event to cause either a Minor alarm, or a Major alarm, or
both.
To learn more about Minor and Major alarms, see
page 352.
Note that the GNSS receiver must initially be tracking more than the configured
number of satellites in order for this alarm to be triggered (the alarm is triggered
when the receiver falls below the number of Minimum Satellites you specified
above).
4.2.4

Setting Up SNMP Notifications

SNMP Notifications are SNMP traps that occur on a change of a monitored event.
To configure SNMP notifications:
For more information on SNMP, see
4.2.5

Setting Up Email Notifications

The Email Setup window provides a means to configure SecureSync with the
necessary settings to interface it with Exchange email servers and Gmail.
To set up Notification Emails (Standard Mode):
CHAPTER •
4 SecureSync 2400 User Manual Rev. 5.2
3. In the Minimum Satellites
that must be available before the alarm is triggered. The alarm will be
triggered when the number of satellites available is
4. In the Duration Below Threshold (s)
the system must be below the threshold set in the
before an alarm is triggered. The alarm will be triggered when this time is
reached.
By default, this timeout value is set to 0 seconds: As soon as the receiver
drops below the minimum number of satellites, the associated alarm is
triggered. A delay of e.g., 5 seconds, however, would not trigger an alarm if
the number of received satellites drops below the specified number for
only 3 seconds.
1. Navigate to MANAGEMENT > OTHER:
2. In the Actions panel, click
fields enter the minimum number of satellites
fields, enter the time
"Minor and Major Alarms" on
Notifications.
SNMP Setup.
"SNMP" on page 100.
4.2 Notifications
BELOW this number.
in seconds that
Minimum Satellites field
269