Safran SecureSync 2400 User Manual page 158

2.15 Configure NTP
3. Once it is enabled, click
4. To enable OSPF IPv4 Anycast, check Enable under the
When the NTP Anycast Expert Mode window is opened, the files displayed are
the configuration files in their current states. If no configuration was done outside
of Expert Mode, these will be the factory default files. If Anycast configuration
was already done from the Web UI, you will be able to edit the existing Anycast
setup.
When editing zebra.conf in expert mode, you should ensure that the first line
under an interface line is an ip address line declaring an IPv4 address (if there is
one for the interface), and that the next line is an ipv6 address line declaring an
IPv6 address (if there is one for the interface). No other lines or variations in spa-
cing should be inserted before or between these lines. No editing restrictions
exist on ospfd.conf or ospf6d.conf files.
Example
same port:
(Interface eth0 line, followed by IPv4 line and then IPv6 line)
*****************************************************
!
interface eth0
ip address 10.2.100.157/16
ipv6 address 2000:10:2::157/64
!
interface lo
ip address 10.10.14.1/32
ipv6 address 2000:10:10::1/64
*****************************************************
Example
ports:
(Interface eth0 line, followed by only IPv4 line, because no IPv6 address is con-
figured on that port. Interface eth1 line, followed by only IPv6 line, because no
IPv4 address is configured on that port)
*****************************************************
142
mode window will appear, with a separate tab for each of the three con-
figuration files.
OSPF IPv6 Anycast, check Enable under the
Anycast, check Enable under the
file with both IPv4, and IPv6 configured on the
zebra.conf
file with IPv4, and IPv6 configured on different
zebra.conf
NTP Anycast in the Actions
BGP tab. Then click Submit.
CHAPTER
2
Panel. The Expert
OSPF tab. To enable
OSPF6 tab. To enable BGP
•
SecureSync 2400 User Manual Rev. 5.2