Ethernet Monitoring - Safran SecureSync 2400 User Manual

This Reference Phase Offset Data is plotted over time (abscissa) in the Reference
Monitor panel in the center of the screen. Use the check boxes in the References
panel
data. Use the handles
The scale of the axis of ordinate
of the references displayed in the current time window. Use the checkboxes in
the References panel on the right to remove references from the graph, or add
them to it.
4.5.1.5

Ethernet Monitoring

To monitor Ethernet status and traffic:
The data displayed is linked to a specific Ethernet port e.g., ETH0. If you enable
additional Ethernet ports, their throughput data will also be displayed.
In the Traffic pane on the right the traffic throughput in Bytes per second is dis-
played in two graphs. Drag the handles at the bottom of the graphs to zoom in
on a particular time frame.
In the Actions panel on the left, you can clear or download monitoring data.
In the Status panel on the left, information pertaining to the given Ethernet port
is displayed, including throughput statistics and error statistics. The Mode field
indicates which transmission mode is being used for the given Ethernet port:
CHAPTER •
4 SecureSync 2400 User Manual Rev. 5.2
(2) to select the reference(s) for which you want to plot the phase offset
(3)
1. Navigate to TOOLS > SYSTEM: Ethernet
screen opens:
FULL duplex, or
HALF duplex.
to zoom in on a time window.
(4) is determined by the largest amplitude of any
4.5 Quality Management
Monitor. The Ethernet monitoring
309