Safran SecureSync 2400 User Manual page 396

APPENDIX
d. Remove screws securing the card already populating the bottom slot. Save
e.
f. Insert option card into the slot above the existing card, lining up the screw
g. Using the supplied M3 screws, screw the board into the standoffs, and the
h.
380
the screws.
Screw the 18-mm standoffs into the option card populating the bottom slot
(see Figure below) , applying a torque of 0.9 Nm/8 in-lbs.
Figure 5-8: Bottom card with standoffs installed
holes with the standoffs.
option plate into the chassis, applying a torque of 0.9 Nm/8 in-lbs.
Take the supplied 50-pin ribbon cable and carefully press it into the con-
nector on the extension board (lining up the ribbon cable with PIN 1 on the
board with PIN 1 on the card), then into the connector on the option card
(see Figure below).
SecureSync 2400 User Manual