Safran SecureSync 2400 User Manual page 95

CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
1. Navigate to the MANAGEMENT > Network Setup
2. The Ports panel displays the available Ethernet ports, and their connection
status:
3. To view all configured Static Routes for all Ethernet Ports, or
more Static Routes, click the
4. To add a new Route,
Port, locate the Port listing you want to configure, and click the
ton next to it.
The Static Routes
ing Table, and an
In the Add Route
Static Route to a Port:
Net Address: This is the address/subnet to route to.
Prefix: This is the subnet mask in prefix form e.g., "24". See also
"Subnet Mask Values" on
Router
Click the Add Route
Note:
must be physically connected to the network.
Note:
ports; a route that has been used elsewhere will be rejec-
ted.
TABLE icon in the top-right corner.
view or delete an existing Route for a specific Ethernet
window for the chosen Port will open, displaying its Rout-
Add Route panel.
panel, populate these fields in order to assign a
page 71.
Address: This is where you will go through to get there.
button at the bottom of the screen.
To set up a static route, the Ethernet connector
Do not use the same route for different Ethernet
2.14 Configure Network Settings
screen.
delete
TABLE
one or
but-
79