Safran SecureSync 2400 User Manual page 372

APPENDIX
Web UI Page loc-
MANAGEMENT/
NTP Setup page
NTP Status Sum-
mary panel
Stratum row
MANAGEMENT/
NETWORK page
356
Current Status
ation
Stratum 15
Cannot login or
access the Web UI.
Indication
NTP is not syn- Note: If SecureSync was just
chronized to recently powered-up or
its available rebooted and input references
input ref- are applied, no troubleshooting
erences may be necessary. Allow at
(SecureSync least 10-20 minutes for the input
may have been references to be declared valid
in Holdover and NTP to align to the System
mode, but Hol- Time (allow an additional 35-40
dover has minutes for a new install with
since expired GNSS input).
without the 1. Verify in the Configure Refer-
return of valid ence Priorities table that all avail-
inputs) able references enabled. See
"Configuring Input Refer-
ence Priorities" on
page 205
2. Verify that the Reference
Status on the HOME page
shows "OK" (Green) for all avail-
able references.
3. Verify NTP is enabled and con-
figured correctly. See
Reference Configuration"
on page 120
The following This message is displayed when
error message any value has been added to the
is displayed: Network Access Rules table and
"Forbidden your PC is not listed in the table
You don't have as an Allow From IP address. To
permission to restore access to the Web UI,
access/ on this either
server" 1. Login from a PC that is listed
as an Allow From in this table;
or
2. If it is unknown what PCs
have been listed in the Access
table, perform an
command to remove all entries
from the Network Access Rules
table. This will allow all PCs to
be able to access the Web UI.
SecureSync 2400 User Manual
Troubleshooting
.
"NTP
.
unrestrict