General Configuration Notes; Gpsd Setup - Safran SecureSync 2400 User Manual

2.16.3

General Configuration Notes

2.17

GPSD Setup

GPSD is a free, open-source package used worldwide to manage GNSS systems
and devices. With GPSD support on a SecureSync, users are able to:
GPSD can only be configured to track the SecureSync internal u-blox receiver.
To configure GPSD on the Web UI, navigate to MANAGEMENT > NETWORK >
GPSD Setup to access the GPSD Setup Screen
CHAPTER •
2 SecureSync 2400 User Manual Rev. 5.2
1. Navigate to MANAGEMENT > NETWORK: PTP
2. In the PTP panel, slide the toggle switch to ON or OFF for the desired Eth-
ernet port.
3. Configure your settings using the Edit Settings Panel.
Ensure that the Ethernet port used for PTP is connected to the network.
Navigate to MANAGEMENT > NETWORK: Network
STATUS in the Ports
For a Master Clock: Be sure that valid time and 1PPS references are cur-
rently selected: Navigate to
and confirm Reference Priority
that in order to operate properly as a Master Clock, SecureSync must be
synchronized to a non-PTP reference. The built-in GNSS reference provides
all information needed with no user intervention. Should you, however, be
using a different reference, ensure that it transmits the following inform-
ation.
The proper TAI or UTC time (including the current year).
The current TAI to UTC offset (required even if the reference's time is
in TAI).
Pending leap second information at least a day in advance.
connect to the unit over a network via TCP at the specified port using any
GPSD-compatible software
receive position and timing information from the GNSS receiver in a con-
sistent format, and
use the Web UI (or CLI) to configure the GPSD service and view status
information.
panel.
MANAGEMENT > OTHER: Reference
configuration, and
2.17 GPSD Setup
Setup.
Setup, and verify the
Priority,
Reference Status. Note
155