Safran SecureSync 2400 User Manual page 417

Hide thumbs Also See for SecureSync 2400:

Table of Contents

Reference Priority table; see

Validity: Indicates "OK" (green) if the 1PPS input signal is present and

valid. Indicates "Not Valid" (orange) if the 1PPS input signal is either not

present or is not considered valid.

ining its validity.

Frequency: Displays (in Hertz) the configured frequency of the input fre-

quency signal.

The 1PPS Input signal is analyzed and an absence of the signal triggers a "Not

Valid" indication.

1PPS Output: Edit Window

To configure the settings of the 1PPS output, go to its Edit window. For instruc-

"Configuring Option Card Inputs/Outputs" on

The Web UI list entries for these cards are: 1PPS/Frequency BNC and 1PPS/Fre-

quency RS-485.

The connector number is: J3 (BNC card); J1 (RS-485 card).

The Edit window allows the configuration of the following settings:

present. See

Offset: Used to account for 1PPS cable delays or other latencies in the 1PPS

output. The Offset value is entered and displayed in nanoseconds (ns). The

available Offset range is -500 to +500 ms.

SecureSync 2400 User Manual

ID: Name used to represent this 1PPS input reference in the

"Configuring Input Reference Priorities" on

for more information on reference priorities.

Mode: Displays how the reference mode operates in determ-

Control: Used to control when the 1PPS output signal will be

"Signature Control" on page 183

for more information.

Troubleshooting