Safran SecureSync 2400 User Manual page 573

Command
gpsinfo
gpsloc
gpsmdl
gpsreset
gpssat
gw4cfg
gw4get
gw4set
gw6cfg
gw6get
gw6set
halt
helpcli
hostget
hostset
hotstart
ip4cfg
ip4get
ip4set
ip6add
ip6cfg
ip6del
ip6get
iptables
kdumpset
licenses
SecureSync 2400 User Manual
Applicable to SAASM-equipped SecureSync units only
Displays GNSS latitude, longitude and antenna height
Displays the GNSS Manufacturer and Model
Resets the GNSS Position stored in the unit.
Displays GNSS satellites tracked and maximum signal strength being
received
Display the configured IPv4 gateway
Displays the default IPv4 gateway
Used to configure the IPv4 gateway addresses
Display the configured IPv6 gateway.
Displays the default IPv6 gateway address
Used to configure the IPv6 gateway address
Used to Halt the system for shutdown
Provides list of available commands and syntax
Displays the DNS hostname
Sets the DNS hostname
Initiate a hot start operation on the SAASM GPS receiver
Display the IPv4 static configuration.
Displays IPv4 Ethernet port information (IP address net mask and gate-
way)
Used to set IPv4 Ethernet port information (IP address net mask and
gateway)
Used to add IPv6 Ethernet port information (IP address net mask and
gateway)
Display the IPv6 static configuration
Used to delete IPv6 IP address
Used to obtain the IPv6 IP address
"Network Services" on page 77
See
Run a test event by activating a kernel panic
Displays configured licenses installed (if any)
Description
for more information.
APPENDIX
557